H-JTAG

H-JTAG Q&A (Recommended)

                                      

Q. How to configure debugger (ADS/SDT/REALVIEW)
A. ADS/AXD -> options -> configure target -> add -> choose h-jtag.dll in the h-jtag  
    installation directory. -> click OK
  
    SDT/ADW -> options -> configuration debugger -> target-> add -> choose h-jtag.dll
    in the h-jtag installation directory -> click OK
  
    RealView -> File -> Connection -> connect to target -> Right click on ARM ->
    Add/Remove/Edit Devices -> Add DLL -> Choose H-JTAG.DLL in the h-jtag
    installation directory -> Select H-JTAG.DLL and then click Configure

Q. How to configure KEIL
A.  KEIL->PROJECT->OPTIONS FOR TARGET->DEBUG->USE RDI Interface Driver 
     ->SETTING->BROWSER->Choose H-JTAG.DLL loacted in the installation folder.

Q. Unable to load h-jtag driver
A. It means that the driver for h-jtag hasn't been installed properly.
    Please reinsrall h-jtag with the administrator's right.
   
Q. Too many breakpoints
A. Normally, this is caused by vector catch/semihosting. Enable vector
    catch/semihosting will consume the breakpoint resource. If all the
    breakpoint resources are occupied, this message may be displayed.
    Please note that all the breakpoints set for vector catch and semihosting
    are unvisible to users. These breakpoints can't be removed by "delete all
    breakpoint" command. To remove this message, please disable the vector
    catch and semihosting in your debugger setting. 

Q. The statement into which was stepped is singular (i.e. it has no exit)
A. This is caused by unvisible breakpoint set for vector catch/semihosting. 
    To remove this message, please disable vector catch in your debugger
    setting.   

Q. Execution stopped, because of an unknown breakpoint (this indicates an
     internal error).
A. This is caused by unvisible breakpoint set for vector catch/semihosting.
    To remove this message, please disable vector catch in your debugger
    setting.   

Q. The processor is reset
A. To remove this message, please disable vector catch in your debugger
    setting.  

Q. Unrecognized swi
A. To remove this message, please disable semihosting in your debugger
    setting.  

【作者: Twentyone】【访问统计:】【2005年08月26日 星期五 17:49】【 加入博采】【打印】